Frost line depth in Phillips County, Montana
Frost reaches about 57 inches in typical soil across Phillips County, from 50″ in the mildest ZIP code to 60″ in the coldest. Codes in this climate commonly set footing depth at 48 to 72 inches.
Severe frostFrost depth by soil type
| Soil type | Est. frost depth |
|---|---|
| Sand / gravel (drains well) | 72″ |
| Silt / loam (typical yard soil) | 57″ |
| Clay (holds water) | 49″ |
County average. Methodology.
Verify before you dig. These are climate-based estimates. The legally required frost depth is the figure your building department publishes in its IRC Table R301.2 (climatic and geographic design criteria). Call the Phillips County building or permitting office in Montana and call 811 before digging.
Frost depth by ZIP code in Phillips County
What this means for your project in Phillips County
Deck footings & piers
Footings must bear below the frost line and at least 12″ below undisturbed ground. For planning in this area, budget for holes around 72″ deep until your permit office confirms the exact figure.
Fence posts
Set posts at least one-third of their above-ground height. Where frost heave is a problem, carry concrete footings below the frost line (about 57″ here in typical soil) and bell or taper the bottom.
Water & irrigation lines
Bury supply lines below the frost depth. Your water utility or plumbing code sets the minimum cover; in a climate this cold, 4 feet or more is common for service lines.
Slabs & frost-protected foundations
Frost-protected shallow foundations (IRC R403.3) use the 100-year air freezing index — 3,400 °F-days here — to size perimeter insulation, letting footings sit shallower than the frost line.
Weather stations used
| NOAA weather station | Distance | 100-yr AFI |
|---|---|---|
| Forks 4 Nne, MT | 31 mi | 3,688 |
| Turner, MT | 35 mi | 3,440 |
| Harlem, MT | 39 mi | 3,235 |
| Opheim 12 Sse, MT | 76 mi | 3,991 |
Nearby counties
Common questions
What is the frost line depth in Phillips County?
About 57 inches in typical soil, based on NOAA's 100-year air freezing index. Across the county's ZIP codes the estimate runs from 50 to 60 inches.
How deep should footings be in Phillips County, Montana?
Codes in climates like this commonly require 48 to 72 inches. The Phillips County building department publishes the required frost depth in its adopted code (IRC Table R301.2).
Does frost depth vary within Phillips County?
Yes. Estimates differ by 10 inches between the coldest and mildest ZIP codes, mostly from latitude and elevation. Check your own ZIP below.